Stainless Steel M6 Flanged Hex Bolts (25 PCS) - for DIY & Machinery

WorthyGood as OEM Bolts.Head is not very tall and has radiused corners at the top, so it is easy to strip the head where the socket tool engages. There is only about 0.100" or 2.5mm of nice, sharp "hex" for the socket to bite into. I just found that they would turn inside the socket before the torque level I wanted was reached.I bought these for my 2011 MDX rear license plate bracket as the OEM ones were dusty. I had to buy 50 unfortunately, when I only wanted 4. Couldn’t find any smaller lots for stainless. Regardless, I’m satisfied!DRZ400I bought these for a Land Rover LR3/discovery 3/Range Rover sport skid plates. M10x25 is the right size and it has the same 13mm hex head. It is a perfect replacement for LR part KYG500500 which is a stronger 10.9 hardened steel bolt but rusts like crazy on the underside of the car, these stainless bolts should be plenty strong(given I only had 4 of 8 of the originals holding it and they were heavily rusted and the bolt clips these screw into is where this fail anyway. These were around $10 for 10 vs. $7 for a single LR bolt, so $8 vs $56 for the 8 bolts required!I needed some additional bolts to complete construction of my patio gazebo. The instructions said the bolts were M6 20 bolts, and required 10mm sockets, so I came here and found these. I expected to need the same sockets for these bolts, however these took 8mm bolts. Not a big deal, still did what I needed, but something that should be disclosedI would give a 5 star rating for the nut and bolt stainless steel quality.However, I would only give a three star rating for truth in advertising and size information. Average of 4 stars.The nut head size is accurate and uses a 10mm socket.The bolt head size is smaller than 10mm (5/16) inch so it does not match the 10mm and needs an inch socket to install.The advertisement said it is a metric bolt and it is not!It is very frustrating to need two size wrenches to secure the nut and bolt assembly!these are of high quality, well made, threads are well formed and installed in my lathe without issue. great value for this quality.great stuff